5.000kV (Max. Output AC Voltage)The Hybrid 2000 Analyzer is a complete dielectric testing solution with AC Hipot, DC Hipot, Insulation Resistance and DC Resistance testing capability. The Hybrid 2000 combines these four test modes with eight HV scan channels for fast multi-point testing. The Hybrid 2000 has Open/Short Circuit detection for establishing proper device connection and Load/Line regulation to ensure easurement integrity. The digital display and user friendly controls allow test parameters and limits to be set without the high voltage activated.
- Perform hipot & contact resistance testing with one instrument
- Automatic switching for multi-point testing
- Monitor resistance while checking intermittent connections
- Insulation resistance testing up to 5000V DC
- AC Dielectric Withstand Voltage 50 to 5000VAC, Current to 30mA
- DC Dielectric Withstand Voltage 50 to 6000VDC, Current to 10mA
- IR Measurements from 1MΩ to 50GΩ, Test Voltage 50 to 5000VDC
- DC Resistance Measurements from 50mΩ to 100kΩ
- Real and Total Current Measurement
- Built-in Scanner with 8 HV Output Channels for Multi-Point Testing
- Programmable Hi/Lo Limits for Pass/Fail Testing
- Ability to Perform Multiple Tests in Sequence
- Internal Storage and Recall of 50 Test Setups, 20 Steps Each
- Programmable Ramp, Dwell, Test and Fall Times
- Open/Short Circuit Check to Ensure the Device is Connected
- Pause Mode Allows the Operator to Change Device Connection & Continue
- Front Panel Lockout Prevents Changes to the Test Setup
- Automatic Offset to Zero Out Residual Current
- Ground Fault Interrupt (GFI) for auto shutdown if current imbalance >0.5mA
- Fast Cutoff and Quick Discharge of Device Under Test
- RS232 Interface Included Standard
- Front Panel Output Connection
- Built-In Operator Prompted Software Calibration Routine
- CE Marked
Specifications
Max. Output AC Voltage
5.000kV
Max. Output DC Voltage
6.000kV
More Details
AC/DC/IR/DCR Analyzer
